Linkage Kit, Dellorto DHLA carburettor, Mangoletsi, twin cable

Mangoletsi is a long established name in the performance tuning industry, and a leading manufacturer of competition inlet manifolds & throttle linkages. We now offer Mangoletsi's new range of Weber DCOE ‘sliding set-up' throttle linkages.

This new simple design features a cast bracket which fits over the top of the carburettor, holding the linkage neatly to the side of the carburettor. This unique design has an ultra-low profile - the highest point of the linkage is only 5mm higher than the carburettor, ideal if clearance is limited. Each kit is suitable for single or twin carburettor set-ups for in-line engines.

The unique design also gives a wide range of throttle adjustment. Cable travel and spring tension can be adjusted independently. The adjuster can be set to give the desired cable travel, the spring tension can then be set to give the correct throttle shut off. This allows the throttle feel to be fine tuned to the driver's requirements.

All linkage systems supplied with full fitting and set-up instructions. Contents include:

Full Pre-assembled Linkage
Throttle Levers - heavy duty 3mm thick throttle levers and spring compensator levers
Service Pack - 2 bronze bushes; 2 ball joint springs and dust seals; 14 nuts, bolts, washers etc.; 2 Allen keys
Cables -2 off one metre long cables with nylon liners. The bulkhead fixing is with adjustable heavy duty threaded bar on the outer cable with locknuts. Supplied with tie-wraps to support cables
Pedal Block -Easy-fit split pedal block is clamped either side of the pedal shaft with 2 bolts